Coltene/Whaledent Temposil 2 Dentin - 4x5 ml

Product detailed description

Use

1. Clean the prepared stump with water and dry it with a light air stream. Do not overdry the dentin.

2. Clean and dry the inside surface of the makeshift.

3. Remove the cap on the Automix syringe.

4. From the syringe, first squeeze a small amount of material directly onto the paper towel until it is clear that the matrix and catalyst are evenly released. This will ensure proper mixing.

5. Clean the syringe hole immediately and remove any residue.

6. Place the mixing cannula on the syringe so that the tips of the mixing cannula point to the appropriate points in the mouth of the syringe. Rotate the cannula 90 ° clockwise to lock it in place.

7. Apply TempoSil directly from the syringe to the temporary. Apply light pressure with temporary pressure. Hold the compensation in place for 30 - 60 seconds.

8. After solidification, remove material residues.

9. After use, disinfect the mixing cannula and store the syringe for future use with the used mixing cannula attached.

Mixing cannula

The TempoSil syringe is always stored with the mixing cannula attached. This ensures a tight seal and prevents contamination. The mixing cannula is removed before using the syringe again. Try an even flow of both masses and insert a new cannula.

Important

Skin secretions and surfaces contaminated with latex gloves can adversely affect the solidification of A-silicones. Touch the mass and the prepared tooth with properly washed and rinsed hands (wash for 15 seconds with detergent, rinse with water for another 15 seconds) or use vinyl gloves. Eugenol-containing substances or haemostatic agents may also prevent solidification.

High temperatures accelerate and low temperatures slow down solidification.